
)*+,,*
-./
!
))0+)01++,
=!
)(+
42!
*?0
STLF-NA-TRD-REQ-1000 QoS support provides priorities and guarantees to specific network traffic.
Provisions must be made in such a way that ensures fairness amongst
different flows: priority for one or more flows should not necessarily imply that
other flows suffer or never get service.
T
NERA: Test_1.2.13 QoS class
separation, New priorities and
Application-aware classification.
STLF_IF_NONREG_MESH
STLF_IF_NONREG_STAR
STLF_IF_MGMT_RCSTNEW
STLF_IF_RCST_QOS
-
STLF-NA-TRD-REQ-1010 QoS parameters are imposed by applications and may also be customer-
related. The following parameters, taken from IBIS and ITU standards, are
needed as a minimum set to characterize QoS requirements:
Delay tolerance (CTD): maximum elapsed time permitted for a packet to be
passed from the sender, through the network, to the receiver in order to keep
the service at an acceptable level. Setup time (Service access time) and data
transfer delay requirements may both be provided. For interactive services,
the most significant delay is the response time.
Jitter tolerance (CDV): maximum variation permitted in end-to-end transit
delay in order to maintain the service at an acceptable level.
Loss tolerance (CLR): maximum loss permitted (bits, packets or cell) to
keep the service at an acceptable level. The units may be Bit Error Rate, or
Packet/cell error rate.
T NERA: Not applicable ( not a terminal
requirement)
STLF_IF_RCST_QOS
-
STLF-NA-TRD-REQ-1020 The SatLife System shall perform classification of flows on the satellite air
interface according to several criteria.
T STLF_IF_RCST_QOS
NERA: Test_1.2.19 QoS filter
configuration via SNMP
Test_1.2.20 QoS filter
configuration via CLI
-
STLF-NA-TRD-REQ-1025
(OPT)
The number of possible flow classifications shall be increased with respect to
AmerHis.
T STLF_IF_RCST_QOS
NERA: by design
-
STLF-NA-TRD-REQ-1030 The SatLife System shall first serve packets belonging to services requiring
minimum propagation delay and jitter
T STLF_IF_RCST_QOS
NERA: 1.2.18 Simultaneous voice and
data connection
-
STLF-NA-TRD-REQ-1040 A single set of QoS parameters shall be assigned to each RCST
corresponding to the subscriber profile according to SLA.
T STLF_IF_RCST_QOS
NERA: By design
-
Comentarios a estos manuales