
)*+,,*
-./
!
))0+)01++,
=!
)(+
42!
*)10
the TableAnalazer perform the check that SDT are correct :
re-assemble sections from MPEG packets,
re-assemble subTable from sections
TableAnalazer output for SDT ( see tableAnalyser.txt file for full results) :
TableId: 0x42 SubTableId: 0x00010440 subTable Count: 30220 section Count: 90660
TableId: 0x42 SubTableId: 0x00010441 subTable Count: 30220 section Count: 60440
TableId: 0x42 SubTableId: 0x00010442 subTable Count: 30220 section Count: 60440
TableId: 0x42 SubTableId: 0x00010443 subTable Count: 30220 section Count: 30220
***********************************************************************************************************************************
Conclusion:
***********************************************************************************************************************************
Test is OK.
&&& ?
$-!6%%QQ!"#Q!Q++
9$$?!
4--B=@
<9+$@
! 1!4(
/$%
CD(
'!(
$$/!
@
Y% Y
6%%
]"7] & !@
&/!/4 C 7% (3D
?!@!4 C+D
&/!/4 3V/4 G)+C
7% (3D
1!@!4 )!4 1
]7 Q(3]]"7](
-$$5/;!
%A!!4 1(
'!(
$$$!
3*$!
3&
$! <@
<9;$$!
***********************************************************************************************************************************
Log file: "\Ait-ConfigReports\Verification_satLife_3_0\traces\eth_vspLifeTime.dmp"
***********************************************************************************************************************************
use following filter of PID on Ethereal trace :
( mpeg2.pid == 0x09 ) || ( mpeg2.pid == 3328 ) || ( mpeg2.pid == 3337 )
SDT PID et Vsp PID Min et Vsp PID max
TableId = 0x42 ( SDT Actual TS tableID )
***********************************************************************************************************************************
Analysis:
***********************************************************************************************************************************
the SDT subTable is output every 2 sec on each TDM. It contains the data from NMC table ( at the beginning of subtable )
and then data issued from VSP.
After the last SDT section sent by VSP ( line 288 ), the SDT subTable is output 3 times every 2 sec:
Comentarios a estos manuales