
)*+,,*
-./
!
))0+)01++,
=!
)(+
42!
**,0
STLF-NA-TRD-REQ-0170 The RCST Service Management function shall allow the NSM operator to
create a new service by filling a form containing the following parameters:
When the RCST is in bridge mode the mesh/star parameters will apply
depending on the presence of a RSGW, as done for the router mode.
NA - -
STLF-NA-TRD-REQ-0180 SatLife system shall support activity timers associated to ethernet traffic
through the bridge RCST. Whenever this timer times out, the RCST should
perform a log off. This parameter is part of the RCST provisioning.
NA - -
STLF-NA-TRD-REQ-0190 The RCST shall transmit management data towards the MS using the LP
buffer associated to channel “0”. The parameters used for this
communication are obtained at RCST logon.
NA - -
STLF-NA-TRD-REQ-0200 The RCST on semi-dynamic or dynamic bridge mode shall use the HP buffer
associated to channel “0” to transmit C2P signaling data towards the NCC.
NA - -
STLF-NA-TRD-REQ-0210 SatLife system shall support Bridge Mode in star and mesh configurations. NA - -
STLF-NA-TRD-REQ-0220 SatLife system shall consider as the static bridge data to be configurable in
bridge mode the following parameters (this impacts NCC and RCST):
Bridge broadcast transmission data: Channel Id, PID tx, SDR and PDR,
priority level.
Bridge broadcast reception data: couples (RCST MAC@- forward PID)
used by the terminals to transmit broadcast messages.
Bridge bidirectional unicast transmission data: destination MAC@, Channel
Id, PID tx, PID rx, priority, SDR, PDR for each RCST present in the VSN. The
SDR and PDR of the terminals shall be compliant with the VSN capacity
assigned.
NA - -
STLF-NA-TRD-REQ-0230 SatLife system shall support pre-reservation of resources for static bridging in
the NCC from the moment that at least two of the RCSTs of the bridged VSN
have logon into the system. The NCC shall assign in the TBTP the resources
for the provisionned channels involved in the communication as defined in
the RCST SLA and it will allow RBDC up to the value configured.
NA - -
STLF-NA-TRD-REQ-0240 Each RCST shall have a table like the following:
Broadcast PID Rx RCST MAC@
1 aa:bb:cc:dd:ee:01
… aa:bb:cc:dd:ee:02
N aa:bb:cc:dd:ee:0x
NA - -
Comentarios a estos manuales